![]() ![]() ![]() The simulation of the pushback on a higher level we can always make use of special add-on programs such as AES, GSX or FS2Crew. At this point begins the turn to the left or to the right. When pressing the button 1 or 2 the plane is re-backward move until the nose wheel to the position on the ground where the main wheels (main gear) were located at the start with 1 or 2. To be a pushback to carry out used the average flightsimmer is the key combination Shift+P for the straight backward movement of the aircraft followed by the 1 key (to the left) or 2 (to the right) for making the bend. For the newbies, perhaps unknown matter and so an additional tip > To the extent that the published explanation of Wikipedia. The pushback truck pushes the aircraft backwards, and rotates it so that the with the nose in the desired direction of travel. By the jet blast would be in the immediate vicinity of the aircraft prepared material blown away and can collide with aircraft, other equipment, or the gate. In addition, the use of the own engine power of the airplane by means of straalomkering or thrust reversal to a lot of noise, but also risk of damage entail. The aircraft is with another vehicle backwards pushed because there is at the gate little room to run. The attach and detach of airplane and truck, it is with this last method is much faster. ![]() Today is also a system that the pushback truck the nose gear of the airplane above the ground. The pushback is a pushback truck with a rod (the so-called towbar) to the nose wheel of the aircraft is confirmed. The pushback procedure is according to Wikipedia the backwards of an aircraft is ready for departure. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |